Three consecutive heats of QT600-5 wheel hubs were sectioned and tested after the austempering curve was re-tuned on the heat-treatment line.
The window is now held at ±15 °C around the set point instead of ±25 °C. Hardness spread across a single batch fell from 28 HB to 11 HB, and the 0.2 % proof strength stayed inside the 370–400 MPa band on every sample.
The change applies to all QT600-5 parts from the next production run onward. Customers holding an approved sample from before September should request a new first-article report.